TOOL & DIE MAKER

Position Summary:
The Tool and Die Maker is responsible to use all type of tool room equipment such as surface grinder, milling machines, bend saws, cut off saws, pedestal grinders, and other tool room equipment to create and make tooling to match part drawing.

Essential Duties and Responsibilities:

• Ability to grind angles, radiuses, on all tooling to create a high quality, tight tolerance parts. These duties are to be performed within quality and to company standards.
• Read blueprints and use necessary measuring devices to make, or modify existing tooling, tools to new or old job prints.
• Make sure that tools are sharpened and in good working condition before being placed back on shelf or in tool drawers.
• Repair or requisition replacement parts, tooling or hardware as needed to maintain adequate stock.
• Check tooling in and out of tool room computer.
• Set-up and operate all tool room equipment for specific operation.
• Demonstrated ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
• Ability to compute rate, ratio, percent, and to interpret bar graphs.
• Other duties may be assigned that pertain to this classification.

Send Resume to: hr@leadertechinc.com

DIE SETTER

Position Summary:
The Die Setter is responsible for setting stops on machine beds, changing dies, and adjusting components for machines in the Press Room and other areas on the production floor.

Essential Duties and Responsibilities:
– Able to set up punch press progressive dies and troubleshoot them as well.
– Able to perform set-ups on a timely basis with minimum supervision, Minster presses experience a plus.
– Able to operate punch press and other machines.
– Support the fence area with assigned tasks
– Must be able to perform, but not limited to, the following tasks: read blue prints, calipers, micrometers, and other measuring equipment.
– Detects and reports defective materials or questionable conditions to the department supervisor.

Send Resume to: hr@leadertechinc.com

DIE SETTER TRAINEE

POSITION SUMMARY:

-The Die Setter Trainee is an entry-level position that assists with performing setups for the Press Room and other areas on the production floor.

ESSENTIAL DUTIES AND RESPONSIBILITIES:

-Able to set up punch press progressive dies and troubleshoot them as well.
-Able to perform set-ups on timely basis with minimum supervision, Minster presses experience a plus.
-Must be able to perform, but not limited to, the following tasks: read blue prints, calipers, micrometers, and other measuring equipment.
-Detects and reports defective materials or questionable conditions to the department supervisor.
-Maintains the work area and equipment in a clean and orderly condition and follows all safety regulations.

Send Resume to: hr@leadertechinc.com